Questions? Call us!
+1 (978) 295-7538
Mon-Fri: 9AM - 8PM ET
Mold Remediation Equipment for Professional Contractors
A mold job needs four things working together: containment that holds, air that gets filtered, moisture that comes out of the structure, and spores that get captured instead of redistributed. This category carries the machines that do each of those jobs, from HEPA vacuums and air scrubbers through negative air machines and LGR dehumidifiers.
What Equipment Does a Mold Remediation Job Actually Require?
Containment comes first. A negative air machine ducted outside the barrier holds the work area under negative pressure so spores do not migrate into clean parts of the structure. Inside the containment, an air scrubber running on true HEPA filtration cuts airborne spore counts while crews work. Once the material is removed, a HEPA vacuum rated for fine particulate captures what settled, and a dehumidifier pulls the structure back down to a stable moisture content so the mold does not return. The EPA's guidance on mold cleanup treats containment and HEPA filtration as the baseline for jobs beyond roughly 10 square feet.
How Much Filtration and Airflow Do You Need?
True HEPA means 99.97% capture at 0.3 microns, and on mold work that rating is the point rather than a marketing line. For airflow, size the machine to the room instead of the label: multiply room volume in cubic feet by your target air changes per hour, then divide by 60. A 20 by 25 foot room with 8 ft ceilings at 6 ACH needs roughly 400 CFM of scrubbing capacity. Filter loading and ducting both cut delivered airflow below the rated number, so leave headroom rather than buying exactly to the calculation.
Why Dehumidification Decides Whether the Job Holds
Removing visible growth without correcting the moisture that caused it produces a callback. Low grain refrigerant dehumidifiers keep pulling water at low dew points, which is what actually brings framing and substrate to a stable reading. Conventional refrigerant units stall once the air dries out. Document the drop with a moisture meter, because readings are what prove the structure reached a dry standard.
Choosing the Right Mold Remediation Equipment
- Start with containment class: Jobs past roughly 10 sq ft of growth need a sealed barrier under negative pressure, which means a machine with a duct collar rather than a recirculating scrubber.
- Confirm true HEPA, not "HEPA-type": Mold work requires 99.97% at 0.3 microns. Anything described as HEPA-like or HEPA-style does not meet it.
- Size airflow to the room: Room volume times target ACH, divided by 60. Add headroom for filter loading and any ducting runs.
- Choose LGR for the drying phase: Standard refrigerant units stop removing meaningful water once the air is dry. LGR keeps going down to the dew points a structural dry needs.
- Check power before the fleet, not after: Scrubbers, negative air machines, and dehumidifiers often run at once. Add the amp draw against the circuits actually available on site.
Related: Air Scrubbers for Mold · Negative Air Machines · Mold Remediation Dehumidifiers · HEPA Equipment for Mold