Pure Water Power 272-27-15-PWP Double RO/DI + 30 ft Carbon Fiber Pole – 1.75 GPM

Pure Water Power Double RO/DI Package with 30-Foot Carbon Fiber Pole – 272-27-15-PWP

The Pure Water Power 272-27-15-PWP bundles the PWP Double RO/DI purification system with a 30-foot, 3.5 lb carbon fiber water-fed pole into one ready-to-run window cleaning setup. The double RO/DI system produces 1 to 1.75 GPM at 50 PSI — no booster pump required — and outputs 0 TDS water through a four-stage filter train: 10" sediment, 10" carbon block, dual 40" RO membranes, and a 10" DI canister. The system mounts on a powder-coated steel frame with flat-free wheels and brass quick-connect fittings for fast job-site setup and breakdown.

272-27-15-PWP System Components and Filter Specs

• Filtration stages: 4-stage — 10" sediment pre-filter, 10" carbon block, dual 40" RO membranes, 10" DI polishing canister
• Flow rate: 1–1.75 GPM at 50 PSI — dual membranes double output versus a single RO system; supports two poles simultaneously
• TDS output: 0 ppm — RO removes 98% of dissolved solids; DI stage polishes to 0 TDS for spot-free results
• Pole: 30 ft, 5-section carbon fiber, 3.5 lbs — lightweight and rigid for reach without fatigue
• Hose: 40 ft included — connects system to pole brush with on/off valve at handle
• Brush: 16" hybrid, 4 pencil jets — thorough rinsing across window surface
• Frame: powder-coated steel, flat-free wheels — stable on job sites, rolls easily on uneven surfaces
• Fittings: all-brass quick-connect — standard garden-hose inlet compatible, brass swivel compression on rubber hoses

Window Cleaning Applications and Water Quality Scenarios

The double RO/DI architecture makes this package the right choice for professional window cleaners working in medium-to-high TDS water regions, where a single RO membrane cannot reduce dissolved solids fast enough to maintain 0 TDS output throughout a full workday. Running dual membranes extends DI resin life significantly because the RO stage removes 98% of solids before water ever reaches the deionization canister — meaning the DI resin lasts far longer than in systems relying on DI alone. The 1.75 GPM peak flow rate at 50 PSI is sufficient to run two water-fed poles at once, making this system practical for two-person window cleaning crews cleaning commercial storefronts, multi-story residential buildings up to five stories, and post-construction glass cleaning where mineral deposits and construction dust require aggressive rinsing.

RO/DI System Setup, Pole Connection, and Operating Requirements

The 272-27-15-PWP connects to a standard garden hose tap — no booster pump or dedicated water line required at pressures of 40–80 PSI. The system arrives pre-assembled on its steel cart; connect the inlet hose to a tap, route the 40-foot output hose to the carbon fiber pole's base fitting, and open the on/off valve at the pole handle to begin cleaning. The dual 40" RO membrane housings are stainless steel for corrosion resistance. Filter replacement follows a standard sequence: sediment and carbon pre-filters every 3–6 months depending on water quality, RO membranes annually, and DI resin when a TDS meter at the outlet reads above 10 ppm. The carbon fiber pole's five-section design collapses for transport and locks at each section for rigid extension to 30 feet.

Documents

Manual