Bissell BGUS1500 15" Upright Floor Scrubber Dryer – 900W, 3400 sq ft/hr, 5.5" Low

Bissell BGUS1500 15" Upright Floor Scrubber and Dryer for Hard Commercial Floors

The BGUS1500 scrubs and dries hard floors in a single pass using injection/extraction technology — solution goes in, dirty water comes out, and the floor is immediately walkable. The 5.5-inch base height reaches under furniture and fixtures that walk-behind scrubbers cannot access. At 23.3 pounds with a 2.8-pound handle weight, it covers 3,400 square feet per hour at 70 dB — within the acceptable range for daytime cleaning in occupied commercial spaces.

BGUS1500 Scrubber-Dryer Specs and Coverage Data

• Motor system: 900 watts total — 650W suction + 250W brush motor at 1,500 RPM
• Cleaning path: 15 inches (suction width: 14 inches)
• Coverage rate: 3,400 sq ft/hr — practical benchmark for shift planning
• Base height: 5.5 inches — reaches under furniture and fixed fixtures
• Tank configuration: separate 2.6L solution and 2.6L recovery tanks
• Brush speed: 1,500 RPM — consistent agitation through the 250W brush motor
• Airflow: 89.3 CFM (43 lt/sec)
• Water lift: 70.9 inches (1,800 mm H₂O) — effective recovery of solution and soils
• Power cord: 41 ft — 80-foot cleaning radius per outlet
• Noise level: 70 dB — within daytime occupied-space cleaning range
• Weight: 23.3 lbs total (2.8 lbs handle weight)
• Maintenance: tool-free squeegee and roller removal
• Sealing: IPX4 — rated for wet cleaning environments

Injection/Extraction Technology vs Traditional Mopping

Traditional mopping deposits dirty water in streaks across the floor and leaves the surface wet for extended periods. The BGUS1500's injection/extraction system applies clean solution through the brush at controlled flow, then immediately recovers the solution and dislodged soils through the squeegee and suction path into the separate recovery tank. The result is a floor that uses less total water than mopping, carries no cross-contamination risk between areas (dirty water is always in the recovery tank, not the solution tank), and is dry enough to walk on immediately after the machine passes. This is particularly relevant in healthcare, food service, and retail environments where wet floors create slip and fall risk.

Upright Floor Scrubber-Dryer Specification for Facilities

The BGUS1500 ships with what's in the box: the machine with dual tanks installed, a 41-foot power cord, and tool-free maintenance access to squeegees and the brush roller. The 2.6-liter tank capacity covers approximately 320 square meters (3,400 square feet) per tank fill, suitable for one to two standard retail floor areas before refilling. The 5.5-inch base height is the key differentiator for facilities with office furniture at standard desk heights — standard walk-behind disc scrubbers cannot reach under desks, reception counters, or store fixtures where the BGUS1500 cleans continuously without lifting or moving furniture.

Documents

BGUS1500 Spec Sheet
BGUS1500 Manual